The printer for the T-Edge is both a printer and a label maker.
The unit comes with a power cord and a USB cord.
To Set the printer up:
Verify the Autoclave is completely off (Both the front on/off switch and the rear).
Plug the USB cord into the printer.
Connect the USB cord to the rear of the T-Edge Autoclave.
Verify the USB cord is connected between the autoclave and the printer.
Plug the printer into power via the included power cord.
Turn on the power switch on the rear of the autoclave.
Wait 3 minutes
This allows the drivers in the autoclave to address the printer.
Turn on the power switch on the front of the autoclave.
Comments
0 comments
Please sign in to leave a comment.